Run 16 TOF+MTD Operations Documents

This page holds TOF and MTD operations documents used during Run-16. Previous versions and possibly current versions may be found on Run-15's equivalent page. [ie: If you do not see the document attached to the bottom of this page, it has not been updated since last run and may be found on the Run-15 page.]

Run 16 TOF + MTD Operations Documents

 

This page is dedicated to hosting documents  to aide in the operation of the TOF, MTD, and VPD subsystems.  Listed below are a list of the documents attached to this page and a brief description.  The .docx files are listed to update the documents as needed.

Canbus_Restart_Procedure.pdf
The first part of the document describes how to restart the canbus interface and the processes dependent on it (recoveryd and anaconda). (This document has been updated since Run-15)
The second part adds a powercycle of the interface to the procedure.

Expert_Knowledge_Base.pdf (This document has been updated since Run-15)
A collection of tidbits for TOF+MTD folk.  Not quite intended for det. operators.

MTD_HVIOC_Restart.pdf
This guides the detector operator on how to restart an HVIOC for the MTD.
  If you want to get super fancy with restarting IOCs, you might want to check their saved states in the ~/HV/HVCAEN*/iocBoot/save_restore_module/*.sav* and see what the IOC is initializing with.  The same thing applies for the LV (MTD/LV/LVWiener*/iocBoot/save_restore_module/) and TOF.

MTD_Power_Cycle_Procedure.pdf
Instructions for the detector operator on performing a LV powercycle.

MTD_LVIOC_Restart.pdf  (This document is new since Run-15)
To guide the detector operator through a MTD LVIOC restart.

Recoveryd_Checking_Restarting.pdf
 This document describes how to check and restart recoveryd.

General_Instructions.pdf (This document has been updated since Run-15) (The document formerly known as "The document Formerly known as General_Instructions" or Responding_To_DAQ_Powercycle_Requests_Monitoring_And_Clearing)
  This document is used as a guide to respond to DAQ powercycle requests and monitoring and clearing errors given by DAQ.

TOF_Freon_Bottle_Switchover_Procedure.pdf
 The document decribes how to monitor the freon and what to do when it runs out.

TOF_HVIOC_Restart.pdf  (This document has been updated since Run-15)
To guide the detector operator through a TOF HVIOC restart.

TOF_LVIOC_Restart.pdf  (This document is new since Run-15)
To guide the detector operator through a TOF LVIOC restart.

TOF_Power_Cycle_Procedure.pdf
Instructions for the detector operator on performing a LV powercycle.