time difference of pulser digis within the same Gbtx (e.g. due to cables) compared to counter 1

variables:

 *** noise rate calculation in run 20336043 ***
# events: 4000000, time window: 3 microseconds, area of half strip: 13.5 cm^2

// -------------------------------
data from second threshold scan

 *** noise rate calculation in run 20103026 ***

Attached are some plots from the HV scan on day 090.

parameters for ToT used to find the pulsers in the events

variables:

Below are some performance plots of the eTOF produced with the fast offline data from runs 20066013 and 20066020.

For the moment we have the noise rates per sector (excluding the channels with pulser input

noise rates 2020

efficiency of hit creation in eTOF counters used for simulation

parameters used in the eTOF MatchMaker

variables:

geometry alignment parameters (local X, localY, localZ, rotation angles ) of the eTOF counters

variables:

detector resolution (local X, localY, time) of the eTOF counters

variables:

parameters used in the eTOF HitMaker

variables:

parameters used in the eTOF CalibMaker

variables:

parameter for common T0 offset correction to sync the eTOF with the bTOF clock ( could be on run-by-run basis )

variables:

parameters for the timing window of eTOF digis on each AFCK board

variables:

parameters for the slewing corrections applied to the eTOF digis in each channel and ToT bin

variables:

calibration parameter applied to the time of the eTOF digis in each channel

variables:

calibration parameter applied to the ToT of the eTOF digis in each channel

variables: